01-Benchmark marking elements & holders 1.2 Lowstress Types Special Engineered type gives lower stress levels in the component when marking. Especially for use in the Aircraft, Nuclear and Oil Industries.   Used when multi-character marking is required. Set of 100 characters (Alpha-Numeric & Punctuation) along with 12 spacers. Provides straight line accurate marking on your component. Can be used with hand holders or machine holders. Set of 50 characters (Alpha-Numeric & Punctuation) along with 6 spacers also available! Ministress Type has special rounded characters for low stress marking. Used where reduced stress marking is required. Dotstress has even greater reduced stress levels and enhanced fatigue properties. Producing a character with similar nose formation to minimize stress but with the added benefit of impressing the character in a dot form which further reduces stress levels in the component. Ministress mark in steel Ministress characters have specially rounded characters to reduce stress levels in marked components. Dotstress mark in steel Dotstress punches use rounded dots to form the character, minimising stress levels. Lowstress Punches / Handstamps are available in all sizes as per demand. Always take the character measurement from the "crown" of the character     Address: 206, Alpine Industrial Estate, Marol Millitary Road, Marol, Andheri (E), Mumbai-400 059. INDIA Telphone No: (00) (91) 22 2920 6910, (00) (91) 6704 9747, Telefax: (00) (91) 22 2920 6754 Mb.:+91 92243 24378 Email: sales@benchmark63.com 1111 1111 ©Copyright 2009 Benchmark.Site Designed & Developed by kalasiddhi.com